Structure defining the parameter in SRADSuperMoonSettings
Remarks
perf_en
Performance test. Default value = 0
opEthGen
opEth1
network_enables
Not applicable for RAD SuperMoon. Set to 0
network_enables_2
Not applicable for RAD SuperMoon. Set to 0
network_enabled_on_boot
Normally neoVI only initiates its comm channels when CoreMini is running or if neoVI is online with DLL/Vehicle Spy 3. Practically this means the the CAN controllers stay in Listen Only mode until the device goes online. Once online the neoVI loads the user settings. Setting this parameter to 1 will change this behavior so that the neoVI enables its controllers immediately on boot.
Default value = 0
network_enables_3
Bitfield containing the software license enables. Depending on the hardware license purchased the customer may have to conditionally select which hardware channels to enable. For example the neoVI Red license allows the user to enable any 2 Dual Wire CAN channels and any 2 LIN channels. To enable a specific network its corresponding bit must be set (1). In order to transmit or receive on a network it must be enabled.
text_api
pc_com_mode
Not Available
timeSyncSettings
hwComLatencyTestEn
Not Available
gPTP
See structure
See structure
See structure
See structure
See structure
OP_Ethernet1 : 4
OP_Ethernet2 : 5