<StructLayout(LayoutKind.Sequential, Pack:=2)> Public Structure SRADSuperMoonSettings
Dim perf_en As UInt16
Dim opEthGen As OP_ETH_GENERAL_SETTINGS
Dim opEth1 As OP_ETH_SETTINGS
Dim network_enables As UInt16
Dim network_enables_2 As UInt16
Dim network_enabled_on_boot As UInt16
Dim network_enables_3 As UInt16
Dim text_api As STextAPISettings
Dim pc_com_mode As UInt16
Dim timeSyncSettings As TIMESYNC_ICSHARDWARE_SETTINGS
Dim hwComLatencyTestEn As UInt16
Dim gPTP As RAD_GPTP_SETTINGS
Remarks
Item
Description
[StructLayout(LayoutKind.Sequential,Pack=2)]
public struct SRADSuperMoonSettings
{
public UInt16 perf_en;
public OP_ETH_GENERAL_SETTINGS opEthGen;
public OP_ETH_SETTINGS opEth1;
public UInt16 network_enables;
public UInt16 network_enables_2;
public UInt16 network_enabled_on_boot;
public UInt16 network_enables_3;
public STextAPISettings text_api;
public UInt16 pc_com_mode;
public TIMESYNC_ICSHARDWARE_SETTINGS timeSyncSettings;
public UInt16 hwComLatencyTestEn;
public RAD_GPTP_SETTINGS gPTP;
}
End Structure
OP_ETH_GENERAL_SETTINGS opEthGen;
OP_ETH_SETTINGS opEth1;
uint16_t network_enables;
uint16_t network_enables_2;
uint16_t network_enabled_on_boot;
uint16_t network_enables_3;
STextAPISettings text_api;
uint16_t pc_com_mode;
TIMESYNC_ICSHARDWARE_SETTINGS timeSyncSettings;
uint16_t hwComLatencyTestEn;
RAD_GPTP_SETTINGS gPTP;
}SRADSuperMoonSettings;
perf_en
Performance test. Default value = 0
opEthGen
See structure
opEth1
See structure
network_enables
Not applicable for RAD SuperMoon. Set to 0
network_enables_2
Not applicable for RAD SuperMoon. Set to 0
network_enabled_on_boot
Normally neoVI only initiates its comm channels when CoreMini is running or if neoVI is online with DLL/Vehicle Spy 3. Practically this means the the CAN controllers stay in Listen Only mode until the device goes online. Once online the neoVI loads the user settings. Setting this parameter to 1 will change this behavior so that the neoVI enables its controllers immediately on boot.
Default value = 0
network_enables_3
Bitfield containing the software license enables. Depending on the hardware license purchased the customer may have to conditionally select which hardware channels to enable. For example the neoVI Red license allows the user to enable any 2 Dual Wire CAN channels and any 2 LIN channels. To enable a specific network its corresponding bit must be set (1). In order to transmit or receive on a network it must be enabled.