DEFCON32 Badge Edition
Last updated
Last updated
The Defcon32 badge is a device that has similar features to the FreeWili hardware. To promote Free Wili and make the almost 30,000 badges more useful we have released a version of the FreeWili code for it for Free (Use at your own risk).
The I2C support is particular well supported making the DEFCON badge a great development tool for DEFCON SAO add-ins.
The badge does not contain all hardware in FreeWili but it does support a significant amount:
Screen
Buttons
Accelerometer
LEDs, light show with up to one LED light strip
IR Transmission
IR Reception with addition of one sensor
I2C control
GPIO control of USER1, USER2, and SAO pins
Sound board with integrated buzzer
USB Serial Console Terminal
WASM Scripting with ROM images
You can load the Free Wili uf2 by forcing the badge into the RP2350 boot loader. This is done by holding both the reset and the bootload button down and then releasing the reset. The reset and boot load buttons are on the back of back shown below.
After doing this the badge will present itself as a mass storage device (USB drive). Simple copy over the FreeWilliDefconVX.uf2 file to the drive. It will reset when it is complete flashing.
The badge has an IRDa sensor. This is not directly compatible with IR Remote devices (although IR Transmit works). To use the FreeWili IR features you can add an IRSensor to the SAO connector as shown below. The output of the sensor must be connected to USER 1 as shown.
The recommend and tested sensor is the TSOP38238. It is available from Digikey
The badge has a SAO connector. This is a DEFCON standard IO connector for expansion. The connector has 4 GPIO of which two can be used as I2C. SAO pin in the lower left corner. Please note the I2C pins have pull up resistors. Also, the badge has 3 devices (touch screen, accel, rtc) already connected to the i2c.
The schematic of the badge SAO connector is below.
Free Wili allows you to use these as i2c, PWM, IR Rx, GPIO or LED light strip control.
The free wili badge firmware does not support the touch screen or RTC devices on the badge. This is a great use for WASM scripting. You can write WASM scripts that send and received I2C data.
