Tutorial: Standalone Video Logging - Part 2 - Setting Up Vehiclescape DAQ
PreviousTutorial: Standalone Video Logging - Part 1 - Setting up the Axis CameraNextTutorial: Standalone Video Logging - Part 3 - Extracting the Video
Last updated
Last updated
Copyright © 2024 | All Rights Reserved
Open up Vehicle Spy, then open 'Measurement' -> 'Vehiclescape DAQ' and select the 'Standalone Logging' tab (Figure 1 
).
Set up the rest of the 'Standalone Logging' settings to the needs of the project. For information on this see the Standalone Logging Tutorial.
Scroll to the bottom of the 'Standalone Logging' tab and find 'Generate'. Click on 'Generate' (Figure 3 ) to open the CoreMini window.
Look for Ethernet DAQ\Filter (Figure 2 ) about halfway down the Vehiclescape DAQ page. Under Ethernet DAQ\Filter, make sure the 'Video' button (Figure 2 ) is selected. After that, adjust the 3 video settings (Figure 2 
) to whatever suits the particular needs of the project at hand. Remember that higher resolution and higher frame rate will take up more space on the SD card during logging.
In the CoreMini window, make sure the correct hardware is selected (Figure 4 ), then push the 'Send' (Figure 4 ) button near the bottom of the page. Once this is completed, close the CoreMini window. The neoVI device is now ready to start logging video.
